LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Removal & Installation >> Coil Spring >> Installation

Coil Spring: Installation

  1. Inspect the spring insulators for wear or damage. Install new insulators if necessary.
  2. Install the spring insulators on the springs.
  3. Install the springs and the spring insulators in the vehicle. Make sure the springs are correctly seated.
  4. Raise the axle using the special tool.
  5. Connect the shock absorbers to the axle and install new nuts.
  6. Connect the lateral arms to the frame and install new bolts and nuts. Do not tighten at this time.
  7. Using the special tool, raise the axle until the shock absorber is compressed to the previously established alignment mark (curb height).
  8. Tighten both bolts.
  9. Lower the axle and remove the special tool. Remove the jack stand.
  10. Connect the stabilizer bar to the stabilizer bar links. Rotate the stabilizer bar onto the links and install the bushings. Install the nuts.
  11. Install the wheel and tire assemblies. Lower the vehicle.
scientia non olet · About LEMON Manuals