Inspection and Verification
- Verify the customer concern by operating the system.
- Visually inspect for obvious signs of mechanical and electrical damage.
VISUAL INSPECTION CHART
MECHANICAL AND ELECTRICAL CHARTMechanical Electrical - Power relay (located in the battery junction box [BJB])
- Rear flasher (located in the luggage compartment)
- Front flasher (located under the RH side of the instrument panel)
- Emergency flasher relay No. 1 (located in the luggage compartment on the LH side)
- Emergency flasher relay No. 2 (located in the luggage compartment on the LH side)
- Central junction box (CJB) fuses:
- 15 (15A)
- 23 (15A)
- BJB fuses:
- 4 (30A)
- 16 (50A)
- Circuitry
- Loose or corroded connections
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- Verify the stoplamps, turn signals, and hazard warning flasher lamps are operating correctly. Refer to appropriate diagnostic procedures in this article, if necessary.
- If the concern is not visually evident, verify the symptom and refer to the SYMPTOM CHART .
NOTE:
Aftermarket vehicle accessories are not covered in this article. Only factory installed police package circuitry and components are covered.