HVAC System - Manual: Specifications

WARNING: Vehicle is equipped with Supplemental Inflatable Restraint (SIR) system. When servicing vehicle, use care to avoid accidental air bag deployment. SIR system-related components are located in various locations throughout interior and exterior of vehicle, depending on application. Do not use electrical test equipment on or near these circuits. If necessary, deactivate SIR system before servicing components. See appropriate AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.

SPECIFICATIONS

Application

Specification

Compressor Type

Ford FS-10 10-Cyl.

Compressor Belt Tension

⁽¹⁾

Compressor Oil Capacity

⁽³⁾

System Oil Capacity

⁽⁴⁾ 7.5 ozs.

Refrigerant (R-134a) Capacity

38.0 ozs.

System Operating Pressures ⁽²⁾

High Side

125-230 (8.8-16.2 kg/cm² )

Low Side

22-45 psi (1.5-3.2 kg/cm² )

⁽¹⁾	Serpentine belt tension is maintained by automatic tensioner pulley.

⁽²⁾	Specification is with ambient temperature at 80°F (27°C) and engine speed at 1200 RPM.

⁽³⁾

Rotate A/C compressor shaft 6-8 revolutions while collecting oil in a clean measuring device. If amount of oil drained from old A/C compressor is between 3-5 ounces (85-142 ml), pour same amount plus one ounce (30 ml) of clean PAG Refrigerant Compressor Oil or equivalent into new A/C compressor. If amount of oil that was removed from old A/C compressor is greater than 5 ounces (142 ml), pour same amount drained of clean PAG Refrigerant Compressor Oil or equivalent into new A/C compressor. If amount of oil that was removed from old A/C compressor is less than 3 ounces (85 ml), pour 3 ounces (85 ml) of clean PAG Refrigerant Compressor Oil or equivalent into new A/C compressor.

⁽⁴⁾	Use YN-19 PAG Oil (Part No. F7AZ-19589-DA).