LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Pats >> Removal And Installation >> Module-Passive Anti-Theft System (PATS) >> Removal

Module-Passive Anti-Theft System (PATS): Removal

    CAUTION: Prior to removal of module, it is necessary to upload module configuration information to a scan tool. This information needs to be downloaded in to the new module once installed. For additional information; refer to MODULE COMMUNICATIONS NETWORK .
    CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
  1. Disconnect the battery ground cable.
  2. Remove the LH instrument panel insulator.
    1. Remove the pin-type retainers.
    2. Remove the LH instrument panel insulator.
    Fig 1: Removing LH Instrument Panel Insulator
    G03445257Courtesy of FORD MOTOR CO.
  3. Remove the lower steering column cover.
    1. Remove the screws.
    2. Remove the lower steering column cover.
    Fig 2: Removing Lower Steering Column Cover
    G03445258Courtesy of FORD MOTOR CO.
  4. Remove the lower steering column cover reinforcement.
    1. Remove the screws.
    2. Remove the lower steering column cover reinforcement.
    Fig 3: Removing Lower Steering Column Cover Reinforcement
    G03445259Courtesy of FORD MOTOR CO.
  5. Remove the passive anti-theft system (PATS) module and bracket.
    1. Remove the bolts.
    2. Disconnect the electrical connector.
    Fig 4: Removing Passive Anti-Theft System (PATS) Module And Bracket
    G03445260Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals