Programming Method L
NOTE:
Prior to performing programming method, refer to HELPFUL HINTS .
Diagnostic method of programming transmitters:
- Choose Service Bay Functions from the service function card (NGS) or use WDS/IDS/PDS (notice that programming methods with a * next to them can only be done via WDS/IDS/PDS).
- Choose Applicable Module (e.g. DDM, CSM, BSM, etc.)
- Choose Key Fob Programming.
- Press any button on the remote entry transmitter.
- Choose Fob 1, 2, 3, 4, 5 or 6 and press Store.
- Repeat step 4 for additional transmitters.
- Press Cancel to get out of menu.
NOTE:
If transmitters do not appear to be working after procedure is complete, disconnect vehicle battery for 5 minutes, then reconnect and try the transmitter again.