Cruise Control Cable
CAUTION:
Cruise control cable must not be pulled tight, otherwise cruise control may not operate properly.
Remove retaining clip from cruise control servo/actuator cable adjuster. See STEP 1 in Fig 1. Ensure throttle is in fully closed position. Pull on cruise control servo/actuator cable to take up slack, then back off at least one notch so there is approximately 0.118" (3 mm) of slack in cruise control servo/actuator cable. See STEP 2 in Fig 1. Insert cruise control servo/actuator cable retaining clip and snap into place. Verify that throttle linkage operates freely and smoothly.
