LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC Systems - Compressor Servicing >> SANDEN SD-7H15 7-Cylinder >> Clutch Assembly >> Removal (All Models)

Removal (All Models)

  1. Disconnect and isolate the battery negative cable.
  2. Remove the serpentine drive belt.
  3. Unplug the compressor clutch coil wire harness connector.
  4. Insert the 2 pins of the spanner wrench into the holes of the clutch plate. Hold the clutch plate stationary and remove the hex nut. See Figure.
  5. Remove the clutch plate and the clutch shims.
  6. Remove the external front housing snap ring with snap ring pliers. See Figure.
  7. Install the lip of the rotor puller into the snap ring groove exposed in step  6, and install the shaft protector. See Figure.
  8. Install the puller through-bolts through the puller flange and into the jaws of the rotor puller and tighten. See Figure. Turn the puller center bolt clockwise until the rotor pulley is free.
  9. Remove the screw and retainer from the clutch coil lead wire harness on the compressor front housing. See Figure.
  10. Remove the snap ring from the compressor hub and remove the clutch field coil. See Figure. Slide the clutch field coil off of the compressor hub.
scientia non olet · About LEMON Manuals