Removal and Installation

CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.

NOTE: Driver side shown, passenger side similar.

Remove the front seat. For additional information, refer to FRONT SEAT .
Disconnect the electrical connector.

Fig 1: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the nut.

Fig 2: Removing Nut
Courtesy of FORD MOTOR CO.
Pull the buckle (57620) through the cushion opening.
Release the J-clip.

Fig 3: Locating J-Clip
Courtesy of FORD MOTOR CO.
Release the J-clip.

Fig 4: Releasing J-Clip
Courtesy of FORD MOTOR CO.
Remove the bolts.

Fig 5: Removing Bolts
Courtesy of FORD MOTOR CO.
Remove the pivot bolt.

Fig 6: Removing Pivot Bolt
Courtesy of FORD MOTOR CO.
Disconnect the electrical connector.

Fig 7: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.

NOTE: The seat position sensor is attached to the track assembly.

Fig 8: Removing Bolts And Seat Track Assembly

Courtesy of FORD MOTOR CO.

Remove the bolts and the seat track assembly.
To install, reverse the removal procedure.
Check the active restraint system for correct operation.