Removal & Installation (Rear Door)
CAUTION:
Ensure not to enlarge sheet metal holes in door inner panel when drilling rivets.
- Disconnect negative battery cable. Remove door trim panel and protective shield. See DOOR TRIM PANEL under REMOVAL & INSTALLATION in POWER DOOR LOCKS & TRUNK RELEASE - CROWN VICTORIA & GRAND MARQUIS article.Remove pull strap handle. See STEP 1 in Fig 1.
- Disconnect window motor harness connector. See STEP 2 in Fig 1. Using a 1/4" drill, remove 3 window regulator motor bracket rivets from door. See STEP 3 in Fig 1. Move motor with drive cables attached, so motor retaining screws can be accessed. Remove power window motor Torx retaining screws. See STEP 4 in Fig 1.
- Separate window motor from window regulator. Remove window motor through access hole in door. To install, reverse removal procedure. Tighten motor-to-regulator bolts to specification. See TORQUE SPECIFICATIONS . Check window glass for correct operation.
