LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> General Procedures >> Wiper Blade and Pivot Arm Adjustment

Wiper Blade and Pivot Arm Adjustment

NOTE: The windshield wiper pivot arm and windshield wiper blade assemblies are positioned using a key and keyway. If adjustment is necessary, use the following procedure:
  1. Remove the pivot arm. For additional information, refer to PIVOT ARM .
  2. Remove the key from the pivot arm.
  3. Cycle the wiper motor to the PARK position.
  4. Install the LH pivot arm to the specified position above the ramp stop.
    Fig 1: Installing LH Pivot Arm To Specified Position Above Ramp Stop
    G03445295Courtesy of FORD MOTOR CO.
  5. Install the RH pivot arm to the specified position above the ramp stop.
    Fig 2: Installing RH Pivot Arm To Specified Position Above Ramp Stop
    G03445296Courtesy of FORD MOTOR CO.
  6. Lower the pivot arms to the ramp stops.
scientia non olet · About LEMON Manuals