Removal and Installation

NOTE: The power seat backrest recliner assembly must be installed as a new unit. Repair of the power seat backrest recliner assembly components is not acceptable and should not be attempted.

Remove the seat. For additional information, refer to FRONT SEAT .
Remove the seat backrest. For additional information, refer to SEAT RECLINER .
Disconnect the connector.

Fig 1: Disconnecting Connector
Courtesy of FORD MOTOR CO.
Release the J-clip.

Fig 2: Releasing J-Clip
Courtesy of FORD MOTOR CO.
Release the J-clip.

Fig 3: Locating J-Clip
Courtesy of FORD MOTOR CO.
Remove the bolts.

Fig 4: Removing Connector Bolts
Courtesy of FORD MOTOR CO.
Remove the bolts.

Fig 5: Removing Bolts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Fig 6: Installing Bolts
Courtesy of FORD MOTOR CO.

Fig 7: Installing Connector Bolts
Courtesy of FORD MOTOR CO.
Check the active restraint system for correct operation.