Removal (Rear)
- Release the parking brake control, using the parking brake release handle. See Figure
.WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the luggage compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
- Raise the vehicle on a hoist.
- Pull the parking brake adjuster clip downward. See Figure .
- Lower the vehicle.
- Apply the parking brake control fully.
- Raise the vehicle.
- Push up on the parking brake adjuster clip to lock the adjuster. See Figure .
- Lower the vehicle.
- Release the parking brake control, using the parking brake release handle. See Figure .
- Raise the vehicle.
- Disconnect the front parking brake cable and conduit from the parking brake rear cable and conduit at the cable connector. See Figure .
- Press the retaining tabs, and remove the right parking brake rear cable and conduit from the frame. See Figure .
- Disconnect the left parking brake rear cable and conduit retainer from the cable adjuster. See Figure .
- Remove the right parking brake rear cable and conduit retainer bolts. See Figure and Figure .
- Compress the cable retaining clip, and pull the parking brake rear cable and conduit out of the rear disc brake adapter plate. See Figure .
- Disconnect the parking brake rear cable and conduit from the parking brake lever. See Figure .
- Unclip the parking brake rear cable and conduit from the axle housing. See Figure .
- Remove the parking brake rear cable and conduit.
