TCC Mode (Drive Mode)

This mode is used to test TCC engagement and disengagement. With TCC solenoid on or off, ensure gearshift lever is in "D" position and vehicle speed is more than 2 MPH. If TCC solenoid is on, ensure transmission is in 2nd gear or higher, TFT is 60-275°F (16-135°C), brakes are not applied at 20 MPH or less, and engine load is not excessive (i.e., engine lugging).

• Select OSC mode.
• Select Trans-Drive Mode.
• Select PIDs to be monitored.
• Monitor all selected PIDs during test.
• Select Parameters (TCC).
• Press ON, and then SEND to turn solenoid on.
• Press OFF, and then SEND to turn solenoid off.
• Press XXX, and then SEND at any time to cancel any command sent.