Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Detach the accessory drive belt from the A/C compressor.
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Disconnect the A/C compressor electrical connector.
6. Loosen the bolts and slide the A/C compressor down approximately 25 mm (1 in).
- To install, tighten to 25 Nm (18 lb-ft).

7. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

8. To install, reverse the removal procedure.