Rear Door Latch: Service and Repair

REAR DOOR LATCH

Removal and Installation

NOTE: The RH side is shown, the LH side is similar.

1. Remove the rear door trim panel.
2. Position the watershield aside.
3. Release the rear door lock lever rod.
4. Remove the screw and position the interior rear door handle away from the door frame.
5. Disconnect the rear door ajar switch electrical connector.
6. Disconnect the rear door lock actuator electrical connector.
7. Remove the 3 rear door latch screws.
- To install, tighten to 12 Nm (9 lb-ft).

8. Remove the rear door latch.
9. To install, reverse the removal procedure.
- Lubricate the door latch after installation.