Pinout Values and Diagnostic Parameters

ECM Harness Connector Terminal Layout






ECM Terminal and Reference Value

PREPARATION




1. ECM (1) is located behind the passenger side instrument lower panel. For this inspection, remove passenger side instrument lower panel.
2. Remove ECM harness connector.




3. When disconnecting ECM harness connector, loosen (A) it with levers (2) as far as they will go as shown in the figure.
- ECM (1)
- Fasten (B)

4. Connect a break-out box (SST) and Y-cable adapter (SST) between the ECM and ECM harness connector.
- Use extreme care not to touch 2 pins at one time.
- Data is for comparison and may not be exact.

ECM INSPECTION TABLE
Specification data are reference values and are measured between each terminal and ground.

Pulse signal is measured by CONSULT-III.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor. Use a ground other than ECM terminals, such as the ground.