Removal and Replacement

DRAINING
1. Stop engine.





2. Remove drain plug (1) and drain gear oil.
3. Set a gasket on drain plug (1) and install it to final drive assembly and tighten to the specified torque.

CAUTION: Never reuse gasket.

FILLING





1. Remove filler plug (1). Fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.
Oil grade and Viscosity: Refer to MA-9, "Fluids and Lubricants".
Oil capacity: Approx. 1.4 l (3 US pt, 2-1/2 Imp pt)
2. After refilling oil, check oil level. Set a gasket to filler plug (1), then install it to final drive assembly.

CAUTION: Never reuse gasket.