Parking Brake Control: Service and Repair

Removal and Installation

PB-4 Component:

REMOVAL
1. Release parking brake.
2. Remove rear tires from vehicle with power tool.
3. Remove instrument driver lower panel.
4. Disconnect parking brake switch connector.
5. Remove adjusting nut and loosen front cable.
6. Remove device assembly mounting nuts and remove device assembly from vehicle.
7. Remove center console.
8. Separate rear cable from front cable, remove front cable from vehicle.
9. Remove heat insulator of the exhaust center muffler from vehicle.
10. Remove parking brake shoe, and remove rear cable from toggle lever.
11. Remove rear cable mounting bolts and nuts, pull out rear cable from vehicle.

INSTALLATION
1. Install in the reverse order of the removal. Refer to "Component" for tightening torque.

CAUTION: Do not reuse adjusting nut.

2. Adjust parking brake. Refer to, "On-Vehicle Service". Adjustments