Front Driveshaft Disassembly & Reassembly: Disassembly

NOTE:  Be careful not to damage the boot.

Inboard Joint 

• 1. Boot Band - Remove

  Ear clamp type 

  Courtesy of HONDA, U.S.A., INC.

  Low profile type 

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the boot bands:

  • If the boot band is an ear clamp type (A), lift up the three tabs (B) using a flat-tipped screwdriver.
  • If the boot band is a low profile type (C), pinch the boot band using commercially available clamp pincer SPX 14100134 (D).
• 2. Inboard Joint - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Make marks (A) on each roller (B) and the inboard joint (C) to identify the locations of the rollers to the grooves in the inboard joint.

  NOTE:  Do not engrave or scribe any marks on the rolling surface.

  2. Remove the inboard joint on a clean shop towel (D). Be careful not to drop the rollers when separating them from the inboard joint.

• 3. Spider - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the circlip (A)

  2. Make marks (B) on the spider (C) and the driveshaft (D) to identify the position of the shaft

  3. Remove the spider.

  NOTE:  Do not engrave or scribe any marks on the rolling surfaces.

• 4. Inboard Boot - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the inboard boot (B)

  2. Remove the inboard boot

  3. Remove the vinyl tape.

  Outboard Joint 

• 1. Boot band - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Lift up the three tabs (A) using a flat-tipped screwdriver, then release the band.

• 2. Outboard Joint - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Slide the outboard boot (A) partially toward the inboard joint side

  2. Wipe off the grease to expose the driveshaft and the outboard joint inner race.

  Courtesy of HONDA, U.S.A., INC.

  3. Make a mark (A) on the driveshaft (B) at the same level as the outboard joint end (C).

  Courtesy of HONDA, U.S.A., INC.

  4. Securely clamp the driveshaft in a bench vise with a shop towel wrapped around the driveshaft 5. Remove the outboard joint (A) using the 26 x 1.5 mm threaded adapter and a commercially available 5/8"-18 UNF slide hammer (B) 6. Remove the driveshaft from the bench vise.

  Courtesy of HONDA, U.S.A., INC.

  7. Remove the stop ring (A) from the driveshaft.

• 3. Outboard Boot - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the outboard boot

  2. Remove the outboard boot

  3. Remove the vinyl tape.