DTC 1301: GPS Antenna Error
NOTE:
- Check the vehicle 12 volt battery condition first .
- This audio DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information - Refer to: How to Troubleshoot the Audio SystemAudio System Self-Diagnostic Function .
- Check the connectors for poor connections or loose terminals.
- 1. Problem verification:
1. Clear the hard error codes - Refer to: How to Troubleshoot the Audio SystemAudio System Self-Diagnostic Function .
2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.
3. Check for hard error codes - Refer to: How to Troubleshoot the Audio SystemAudio System Self-Diagnostic Function .
Is DTC 1301 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- 2. GPS antenna check (substitution):
1. Clear the hard error codes - Refer to: How to Troubleshoot the Audio SystemAudio System Self-Diagnostic Function .
2. Turn the vehicle to the OFF (LOCK) mode.
3. Substitute a known-good GPS antenna .
4. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.
5. Check for hard error codes - Refer to: How to Troubleshoot the Audio SystemAudio System Self-Diagnostic Function .
Is DTC 1301 indicated?
YES
Replace the audio unit - Refer to: Audio Unit Removal and Installation(With Display Audio)Audio Unit Removal and Installation(With Normal Audio) .
NO
NOTE:
- Check the vehicle 12 volt battery condition first .
- This navigation DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information .
- Check any official Honda service website for more service information about the navigation system.
- Check the connectors for poor connections or loose terminals.
- 1. Problem verification:
1. Clear the hard error codes .
2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.
3. Check for hard error codes .
Is DTC 1301 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
- 2. GPS antenna check (substitution):
1. Clear the hard error codes .
2. Turn the vehicle to the OFF (LOCK) mode.
3. Substitute a known-good GPS antenna .
4. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.
5. Check for hard error codes .
Is DTC 1301 indicated?
YES
Replace the audio-navigation unit .
NO