Crankshaft Pulley Removal & Installation: Installation

1. Crankshaft Pulley - Install

Courtesy of HONDA, U.S.A., INC.

1. Remove any oil and clean the crankshaft pulley (A), the crankshaft (B), the bolt (C), and the washer (D). Lubricate with new engine oil as shown.

Courtesy of HONDA, U.S.A., INC.

2. Install the crankshaft pulley, and hold the pulley with the holder handle (A) and the crankshaft pulley holder (B)

3. Torque the bolt to 50 N.m (5.1 kgf.m, 37 lbf.ft) with a torque wrench and a socket, 19 mm (C). Do not use an impact wrench. If the pulley bolt or crankshaft are new, torque the bolt to 180 N.m (18.4 kgf.m, 133 lbf.ft), then remove the bolt and torque it to 50 N.m (5.1 kgf.m, 37 lbf.ft).

Courtesy of HONDA, U.S.A., INC.

4. Tighten the pulley bolt an additional 90°.

2. Drive Belt - Install
3. Splash Shield - Install
4. Right Front Wheel - Install