Removal & Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

• 1. Glove Box - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the bolts (A).

  Courtesy of HONDA, U.S.A., INC.

  2. Release both glove box stops (A) by pushing them in, then let glove box (B) hang down.

  Courtesy of HONDA, U.S.A., INC.

  3. Detach the glove box damper (A), then remove the glove box (B).

• 2. Glove Box Lock Cylinder - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the glove box lock cylinder trim (A).

  Courtesy of HONDA, U.S.A., INC.

  2. Remove the retainer (A).

  Courtesy of HONDA, U.S.A., INC.

  3. Remove the glove box lock cylinder (A).

• 3. Glove Box Damper - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Detach the hooks (A), then pull out the glove box damper (B).

• 4. Glove Box Striker - Remove

  Courtesy of HONDA, U.S.A., INC.

  Glove box striker type 1 

  1. Remove the glove box striker (A).

  Courtesy of HONDA, U.S.A., INC.

  Glove box striker type 2  1. Remove the passenger's dashboard trim panel . 2. Remove the screws (A) and the bolt (B). 3. Remove the glove box striker (C).

• 5. All Removed Parts - Install

  Courtesy of HONDA, U.S.A., INC.

  Courtesy of HONDA, U.S.A., INC.

  1. Install the parts in the reverse order of removal.

  NOTE:  Before reinstalling the glove box lock cylinder, install the retainer (A) into the slot, then Install the glove box lock cylinder (B).