Mirror Holder Removal and Installation: Replacement

Courtesy of HONDA, U.S.A., INC.

1. Carefully push on the top edge of the mirror holder (A) by hand

2. Put a shop towel in the opening between the bottom edge of the mirror holder and the mirror housing (B) to prevent scratches

3. Insert a flat-tip screwdriver under the mirror holder, and quickly twist the screwdriver to release the hook (C).

Courtesy of HONDA, U.S.A., INC.

4. Apply heat with a heat gun to the gap between the mirror holder (A) and the mirror housing (B). Carefully pull out the bottom edge of the mirror holder to separate the adhesive (C).NOTE:  Do not heat the plastic parts too much or you may damage them 5. Separate the mirror holder from the actuator (D) 6. With power mirror defogger: Disconnect the connectors (E).

Courtesy of HONDA, U.S.A., INC.

1. Install the parts in the reverse order of removal.

NOTE:  Before reinstalling the mirror holder to the actuator (A), check the actuator rods (B) and the actuator boots (C) as shown.