Driver's Power Seat Motor Test: Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

• 1. Front Seat Recline Cover - Remove

  NOTE:  If removing the driver's seat recline cover, you do not need to remove the driver's seat.

• 2. Power Seat Motor - Test

  Courtesy of HONDA, U.S.A., INC.

  Courtesy of HONDA, U.S.A., INC.

  1. Test the motor by applying 12 volt battery power and ground at the driver's power seat adjustment switch connector on the seat harness according to the table. When the motor stops running, disconnect 12 volt battery power immediately.

  2. If the motor does not run or fails to run smoothly, remove the driver's seat , then go to step 4.

  Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC. Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC.

  3. Remove the driver's seat-back cover/pad as needed . 4. Disconnect these connectors: Front up-down motor connector Rear up-down motor connector Recline motor connector Slide motor connector

  Courtesy of HONDA, U.S.A., INC.

  5. Test each motor in each direction by connecting 12 volt battery power and ground according to the table. When the motor stops running, disconnect 12 volt battery power immediately 6. If the motor does not run or fails to run smoothly, replace: Front up-down motor/seat frame Rear up-down motor/seat frame Recline motor/seat frame Slide motor If motors run smoothly, replace the driver's seat wire harness.

• 3. All Removed Parts - Install the parts in the reverse order of removal.