Test Procedure

1. Front Passenger's Door Panel - Remove

2. Front Passenger's Power Window Motor - Test

37P Connector Type

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

10P Connector Type

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

1. Test the motor in each direction by connecting 12 volt battery power and ground to the front passenger's switch power window connector (A) according to the table. When the motor stops running, disconnect 12 volt battery power immediately.

2. If the motor does not run or fails to run smoothly, remove the front passenger's power window regulator , then go to step 3.

Courtesy of HONDA, U.S.A., INC.HONDA, U.S.A., INC.

3. Test the front passenger's power window motor (A) by connecting 12 volt battery power and ground according to the table. When the motor stops running, disconnect 12 volt battery power immediately.
4. If the motor does not run or fails to run smoothly, the front passenger's power window motor is faulty; replace the front passenger's power window motor . If the motor runs smoothly, replace the wire harnesses.

3. All Removed Parts - Install - Install the parts in the reverse order of removal.