DTC C0010-49; DTC C0011-49; DTC C0014-49; DTC C0015-49; DTC C0018-49; DTC C0019-49; DTC C001C-49; DTC C001D-49: Inlet & Outlet Solenoid Circuit Failure
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0010-49 Inlet Solenoid (Left Front) Circuit Failure | ||
| C0011-49 Outlet Solenoid (Left Front) Circuit Failure | ||
| C0014-49 Inlet Solenoid (Right Front) Circuit Failure | ||
| C0015-49 Outlet Solenoid (Right Front) Circuit Failure | ||
| C0018-49 Inlet Solenoid (Left Rear) Circuit Failure | ||
| C0019-49 Outlet Solenoid (Left Rear) Circuit Failure | ||
| C001C-49 Inlet Solenoid (Right Rear) Circuit Failure | ||
| C001D-49 Outlet Solenoid (Right Rear) Circuit Failure |
- 1. Problem verification:
1. Turn the vehicle to the ON mode.
2. Clear the DTC with the HDS.
3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
4. Wait 20 seconds or more.
5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0010-49 Inlet Solenoid (Left Front) Circuit Failure C0011-49 Outlet Solenoid (Left Front) Circuit Failure C0014-49 Inlet Solenoid (Right Front) Circuit Failure C0015-49 Outlet Solenoid (Right Front) Circuit Failure C0018-49 Inlet Solenoid (Left Rear) Circuit Failure C0019-49 Outlet Solenoid (Left Rear) Circuit Failure C001C-49 Inlet Solenoid (Right Rear) Circuit Failure C001D-49 Outlet Solenoid (Right Rear) Circuit Failure Is DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, or C001D-49 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.
- 2. VSA modulator-control unit check (update):
1. Update the VSA modulator-control unit if it does not have the latest software .
2. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
3. Wait 20 seconds or more.
4. Check for DTCs with the HDS.
Is DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, or C001D-49 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.