DTC C0020-12: Pump Motor Circuit Failure (Stuck ON)
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0020-12 Pump Motor Circuit Failure (Stuck ON) |
- 1. Problem verification:
1. Turn the vehicle to the ON mode.
2. Clear the DTC with the HDS.
3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
4. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0020-12 Pump Motor Circuit Failure (Stuck ON) Is DTC C0020-12 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.
- 2. Open wire check (GND line):
1. Turn the vehicle to the OFF (LOCK) mode.
2. Disconnect the following connector.
VSA modulator-control unit 38P connector 3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode VSA modulator-control unit 38P connector: disconnected Test point 1 VSA modulator-control unit 38P connector No. 1 Test point 2 Body ground Is there continuity?
YES
The GND wire is OK. Go to step 3.
NO
Repair an open in the wire between the VSA modulator-control unit and body ground (G201).
- 3. VSA modulator-control unit check (update):
1. Reconnect the following connector.
VSA modulator-control unit 38P connector 2. Update the VSA modulator-control unit if it does not have the latest software .
3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.
4. Check for DTCs with the HDS.
Is DTC C0020-12 indicated?
YES
Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.