VTC Actuator Removal & Installation: Removal

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

1. Check that the VTC actuator is locked by turning the VTC actuator counterclockwise. If it is not locked, turn the VTC actuator clockwise until it stops, then recheck it. If it is still not locked, replace the VTC actuator

2. Seal the retard holes (A) in the No. 1 camshaft journal with tape and a wire tie.

Courtesy of HONDA, U.S.A., INC.

3. Seal one of the advance holes (A) with tape.

Courtesy of HONDA, U.S.A., INC.

4. Apply air to the unsealed advance hole to release the lock.

Courtesy of HONDA, U.S.A., INC.

1. Secure the intake camshaft in a vise with wood blocks, then loosen the VTC actuator mounting bolt.

NOTE:  After this procedure, remove wood chips that may be stuck to the intake camshaft.

Courtesy of HONDA, U.S.A., INC.

2. Remove the VTC actuator.