Inspection Procedure

3. Cylinder Head Warpage - Inspect

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

1. Check the cylinder head for warpage. Measure along the edges, and three ways across the center:

If warpage is less than 0.05 mm (0.0020 in) cylinder head resurfacing is not required.
Maximum resurface limited to the cylinder head height standard as shown.

Cylinder Head Warpage
Standard (New):	0.05 mm (0.0020 in) max.

Cylinder Head Height
Standard (New):	111.95-112.05 mm (4.4075-4.4114 in)

4. All Removed Parts - Install - Install the parts in the reverse order of removal.