DTC P0746: CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF
NOTE: Before you troubleshoot, review the General Troubleshooting Information - Refer to: How to Troubleshoot the Fuel and Emissions SystemsHow to Troubleshoot the CVT System(CVT System) .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF |
- 1. DTC check:
1. Turn the vehicle to the ON mode.
2. Clear the DTC with the HDS.
3. Test-drive the vehicle in D position/mode until the vehicle speed reaches 37 mph (60 km/h). Slow down and stop the vehicle. Then accelerate from a stop at full throttle in D position/mode until the vehicle speed reaches 37 mph (60 km/h).
4. Turn the engine off. Repeat the test-drive in step 1-3 again.
5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0746 CVT Drive Pulley Pressure Control Solenoid Valve Stuck OFF Is DTC P0746 indicated?
YES
The failure is duplicated. Faulty CVT drive pulley pressure control solenoid valve. Replace the lower valve body .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.