DTC P2818: Shift Solenoid Valve O/P (Pressure Control Solenoid "H") Stuck On

NOTE:  Before you troubleshoot, review the General Troubleshooting Information - Refer to: How to Troubleshoot the Fuel and Emissions SystemsHow to Troubleshoot the CVT System(CVT System) .

DTC (CVT)

• 1. DTC check:

  - 1. Turn the vehicle to the ON mode.

  - 2. Clear the DTC with the HDS.

  - 3. Start the engine. With the brake pedal pressed, Shift the transmission to N position/mode, then shift to D position/mode. Release the brake pedal, and test-drive the vehicle in D position/mode at speeds 25 mph (40 km/h) or below for at least 10 seconds.

  - 4. Turn the engine off. Repeat the test-drive in step 1-3 again.

  - 5. Check for Pending or Confirmed DTCs with the HDS.

  DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
  P2818 Shift Solenoid Valve O/P (Pressure Control Solenoid "H") Stuck On

  Is DTC P2818 indicated?

  YES 

  The failure is duplicated. Go to step 2.

  NO 

  Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

• 2. Shift Solenoid Valve O/P operation check:

  - 1. Select the Shift Solenoid Valve O/P Test in the Miscellaneous Test Menu, and check that the shift solenoid valve O/P operates with the HDS.

  Shift Solenoid Valve O/P

  Does the shift solenoid valve O/P work properly?

  YES 

  The shift solenoid valve O/P is OK. Replace the transmission fluid pump .

  NO 

  Faulty the shift solenoid valve O/P. Replace the shift solenoid valve O/P .