VTC Oil Control Solenoid Valve Removal, Installation, & Test: Test

1. VTC Oil Control Solenoid Valve - Test

Courtesy of HONDA, U.S.A., INC.

1. Connect VTC oil control solenoid valve connector terminal No. 1 to the 12 volt battery positive terminal with a jumper wire. Connect VTC oil control solenoid valve connector terminal No. 2 to the 12 volt battery negative terminal with a jumper wire.

Courtesy of HONDA, U.S.A., INC.

2. Measure the clearance of the valve (A). The clearance should be at least 0.047 in (1.2 mm).

If the clearance is as specified, the valve is OK; reinstall it with a new O-ring (B).
If the clearance is not as specified, install a new valve and O-ring.