Removal & Installation

SRS components are located in this area. Review the SRS component locations , and the precautions and procedures before doing repairs or service.

• 1. Steering Wheel - Remove
• 2. Column Cover - Remove
• 3. Cable Reel/Steering Angle Sensor - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Disconnect the connectors (A).

  Courtesy of HONDA, U.S.A., INC.

  2. Remove the cable reel/steering angle sensor (A).

• 4. Steering Angle Sensor - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the steering angle sensor (A) from the cable reel (B).

  NOTE: 

  • If reinstalling these removed parts later, make sure to keep the position of the rotating parts unchanged to reinstall them correctly.
  • During installation, position the two tabs (C) of the steering angle sensor as shown.
• 5. All Removed Parts - Install the parts in the reverse order of removal.
• 6. VSA Sensor Neutral Position - Memorize
• 7. Steering Angle Sensor Neutral Position - Clear