Rear Brake Caliper Removal & Installation: Removal

Courtesy of HONDA, U.S.A., INC.

Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid does contact the paint, wash it off immediately with water.

• 1. Vehicle - Lift
• 2. Rear Wheel - Remove
• 3. Brake Caliper Body - Remove

  Courtesy of HONDA, U.S.A., INC.

  NOTE:  After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.

  1. Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper body (C)

  2. Remove the flange bolts (D) while holding respective caliper pins (E) with a wrench.

  NOTE:  Be careful not to damage the pin boot

  3. Remove the caliper body.

• 4. Brake Pad - Remove 
• 5. Caliper Pin and Pin Boot - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the caliper pins (A).

  NOTE:  The upper and lower caliper pins are different. During installation, make sure the caliper pins are in the proper positions

  2. Remove the pin boots (B).