Removal & Installation

NOTE:  Keep grease away from the brake disc and the brake pads.

• 1. Vehicle - Lift
• 2. Rear Wheels - Remove
• 3. Parking Brake - Release
• 4. Brake Caliper - Remove
  Fig 1: Brake Caliper Assembly With Torque Specifications

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the brake hose mounting bolt (A)

  2. Remove the caliper assembly (B).

  NOTE: 

  • To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage.
  • Do not twist the brake hose and the parking brake cable excessively.
• 5. Brake Disc - Remove

  Courtesy of HONDA, U.S.A., INC.

  1. Remove the brake disc/drum flathead screws (A)

  2. Remove the brake disc/drum (B).

  NOTE: 

  • Remove the access plug (C), then if necessary, turn the adjuster nut (D) with a flat-tip screwdriver until the shoes become loose.
  • If the brake disc/drum is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (E) into the brake disc/drum to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc/drum from binding.
• 6. All Removed Parts - Install

  1. Install the brake disc in the reverse order of removal.

  NOTE:  Before installing the brake disc, clean the mating surfaces between the front hub and the inside of the brake disc.

• 7. Brake Disc Runout - Inspect
• 8. Parking Brake - Adjust