How to Troubleshoot the CVT System(CVT System): Self-Diagnosis

Self-Diagnosis 

If the PCM detects the failure of a signal from a sensor, a switch, a solenoid valve, or from another control unit, it stores a Pending or Confirmed DTC. Depending on the failure, a DTC is stored in either the first or the second drive cycle. When a Confirmed DTC is stored, the PCM blinks the A/T gear position indicator and/or turns on the MIL by a signal sent to the gauge control module via F-CAN.

• One Drive Cycle Detection Method:

  When an abnormality occurs in the signal from a sensor, a switch, a solenoid valve, or from another control unit, the PCM stores a Pending or Confirmed DTC for the failure and blinks the A/T gear position indicator and/or turns on the MIL immediately.

• Two Drive Cycle Detection Method:

  When an abnormality occurs in the signal from a sensor, a switch, a solenoid valve, or from another control unit in the first drive cycle, the PCM stores a Pending DTC. The A/T gear position indicator and the MIL do not turns on at this time. If the failure continues in the second drive cycle, the PCM stores a Confirmed DTC and blinks the A/T gear position indicator and/or turns on the MIL.