Removal & Installation

1. Splash Shield - Remove
2. Engine Coolant - Drain
3. A/C Condenser Fan Shroud and Radiator Fan Shroud - Remove
4. Connector (ECT Sensor 2) - Disconnect
1. Disconnect the connector (A).

Courtesy of HONDA, U.S.A., INC.

2. Remove the harness clamp (B).
5. Lower Radiator Hose - Disconnect

Courtesy of HONDA, U.S.A., INC.
6. Upper Radiator Hose - Disconnect

Courtesy of HONDA, U.S.A., INC.

7. Radiator Assembly - Remove

GHH49097

Courtesy of HONDA, U.S.A., INC.

1. Pull up the radiator assembly (A)

2. Remove the lower cushions (B).

GHH49098

Courtesy of HONDA, U.S.A., INC.

3. Remove the radiator cap (A), the drain plug (B), and ETC sensor 2 (C) from the radiator (D).

8. All Removed Parts - Install the parts in the reverse order of removal.