How to Clear DTCs

How to Clear DTCs 

NOTE:  Make sure the 12 volt battery is fully charged before you begin.

1. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.

2. Connect the HDS to the data link connector (DLC) (A).

3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, go to the DLC circuit troubleshooting .

4. In the SRS MENU of the HDS, select SRS, then DTC to clear DTCs.

5. Turn the vehicle to the OFF (LOCK) mode, then wait for 10 seconds.