Front Passenger's Weight Sensor Output Check After a Vehicle Collision: Check

NOTE:  Check the front passenger's weight sensor output after a vehicle collision.

• 1. HDS - Connect
• 2. Front Passenger's Weight Sensor - Output Check After a Vehicle Collision

  Front Passenger's Weight Sensor Output Check After a Vehicle Collision 

  • Make sure all the components of the front passenger's seat are correctly installed.
  • Position the front passenger's seat all the way rearward, and adjust the seat-back to the forward most position. Do not move the seat from this position until the output check is completed.
  • Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.
  • Make sure nothing is in the front passenger's seat-back pocket.
  • Keep the windows and the moonroof closed (if equipped).
  • Make sure the vehicle is on level ground.
  • Dehumidify inside of the vehicle with A/C.
  • Do not touch the front passenger's seat during the output check.
  • Do not expose the front passenger's seat to sudden temperature changes.
  • Make sure all aftermarket devices (amplifiers, fluorescent light, air purifiers, CB or HAM radios, etc.) are turned off.

  1. Drive the vehicle, accelerate to 22 mph (36 km/h), then stop on level ground

  2. From SRS in the HDS Main Menu, select SWS, then Inspection. In the Inspection Menu, select AFTER A VEHICLE COLLISION. Follow the prompts until the front passenger's weight sensor output check has been completed

  3. Turn the vehicle to the OFF (LOCK) mode.