DTC Fx-11: Airbags and/or Tensioners Deployment Recorded

NOTE: 

• Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed .
• Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
• When any airbag or tensioners have deployed, go to Component Replacement/Inspection After Deployment .

• 1. DTC check:

  1. Clear the DTCs with the HDS .

  2. Turn the vehicle to the ON mode, then wait for 10 seconds.

  3. Check for DTCs with the HDS .

  Is DTC F1-11, F2-11, F3-11, F4-11, F5-11, or F6-11 indicated?

  DTC F1-11

  Driver's airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.

  DTC F2-11

  Front passenger's airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.

  DTC F3-11

  Driver's side airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.

  DTC F4-11

  Front passenger's side airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.

  DTC F5-11

  Both or only one side curtain airbag and front seat belt tensioner deployed.

  DTC F6-11

  Both or only one side curtain airbag and front seat belt tensioner deployed.

  NO DTC

  Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures . If another DTC is indicated, troubleshoot the DTC.