Removal And Installation

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

The heated steering wheel switch located in the switch pod. The heated steering wheel switch cannot be adjusted or repaired. If a heated steering wheel switch indicator lamp is inoperative or damaged, the entire switch pod must be replaced. Refer to POD, SWITCH, REMOVAL AND INSTALLATION .