Removal And Installation: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Lower the window to the full down position.
2. Release the door rear seal retaining clip (1a) using a trim stick.
3. Slightly disengage the end (2a) of the door rear seal from its seat.
4. Apply a double layer of adhesive tape (3a) to the door along the lower edge of the outer belt molding (3b).
5. Raise the outer belt molding (3b) starting from the rear edge (4a), releasing it from its various retainers (4b) with the special tool.
6. Retrieve the outer belt molding (3b).

Courtesy of CHRYSLER GROUP, LLC

INSTALLATION

1. Position the outer belt molding (1a) then fit it in its housing gradually and carefully to avoid damaging it, engaging the retainers (1b).
2. Remove the adhesive tape (2).
3. Position the rear end of the door seal in is seat and engage the retaining clip (3).
4. Move the door window to check that the belt molding is working.