Removal And Installation: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION
.
- Remove the duct to floor nuts (1a).
- Remove the duct (2a) from the HVAC housing and remove from the vehicle.
- Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION
.
- Working on the lower central part of the shelf covering (1a), remove the screws (1b) and remove the Bluetooth antenna (1c) from the vehicle.

