Technical Specifications
NOTE:
Rotor runout specifications are not to be used for diagnosing brake concerns. The values in the table are post turn measurements taken by an on-vehicle brake lathe.
NOTE:
When refacing a rotor, the required rotor runout MUST BE MAINTAINED. Extreme care in the operation of rotor turning (machining) equipment is required.
BRAKING SYSTEM
| 2.9 V6 | 2.0 | ||
|---|---|---|---|
| Type | Electro-hydraulic of "BRAKE BY WIRE" type with Continental ABS MK C1 module | ||
FRONT BRAKES
| 2.9 V6 | 2.0 | ||
|---|---|---|---|
| Steel Disc | Carbon-Ceramic Disc | ||
| Disc type | Self-venting | ||
| Disc diameter (mm) | 360 ± 0.4 | 390 ± 0.2 | 305 ± 0.2 (Small Version) 330 ± 0.2 (Large Version) |
| Nominal Thickness (mm) | 32 ± 0.2 | 34.5 ± 0.35 | 28 ± 0.2 |
| Minimal Thickness after Machining (mm) | 30.3 | - | 26.35 |
| Minimal Thickness allowed (mm) | 29.5 | 33.35 | 25.5 |
| Caliper piston diameter (mm) | 6 Pistons of : 38 - 34 - 30 | 6 Pistons of : 38 - 32 - 28 | 4 Pistons of : 40 |
| Rotor Runout (mm) | 0.020 mm (0.0008 in.) | ||
REAR BRAKES
| 2.9 V6 | 2.0 | ||
|---|---|---|---|
| Steel Disc | Carbon-Ceramic Disc | ||
| Disc type | Self-venting | ||
| Disc diameter (mm) | 350.0 ± 0.4 | 360.0 ± 0.2 | 292.0 ± 0.2 (Small Version) 320.0 ± 0.2 (Large Version) |
| Nominal Thickness (mm) | 28 ± 0.1 | 28 ± 0.1 | 22 ± 0.1 |
| Minimal Thickness after Machining (mm) | 26.35 | - | 20.55 |
| Minimal Thickness allowed (mm) | 25.5 | 27.5 | 20.0 |
| Caliper piston diameter (mm) | 4 Pistons of : 34 - 40 | 4 Pistons of : 34 - 40 | 42 |
| Rotor Runout (mm) | 0.020 mm (0.0008 in.) | ||