QUADRIFOGLIO - Carbon Ceramic: Removal

NOTE:

Removal process is the same for both sides of the vehicle.

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
Open the brake fluid reservoir and check the fluid level.
NOTE:
The piston retraction operations described here below increase the brake fluid level in the reservoir. Make sure the fluid level does not cause leakage.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the brake pad wear sensor wire harness electrical connection (1) and release the electrical connection from the retaining bracket.

Courtesy of CHRYSLER GROUP, LLC
Using a suitable tool, retract and remove the brake caliper pins (1).
Remove the brake caliper retaining clip (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (1a) and remove the tensioner (1b).
NOTE:
Piston retraction must be such so allow extracting the worn pads and then inserting the new ones.
Retract the pistons from the brake caliper using a retractor or other suitable tool pressing on the worn pads.

Courtesy of CHRYSLER GROUP, LLC
Remove the brake pads (1a) together with the pad wear indicator wiring (1b).
If the pads are stuck to the pistons, use a suitable tool to extract the pads from the caliper. Be careful not to damage the pistons and the dust boots.
NOTE:
Do not use products which could damage rubber.
Carefully clean the pad seat area using suitable materials and products (e.g. a moist cloth).
Check that there is no damage to the pistons or the dust boots.