QUADRIFOGLIO - Non Carbon Ceramic: Installation
- Install some "MOLYKOTE Cu-7439 Plus" grease to the brake pad sliding shoulders (1).
- Install a NEW
brake retaining spring (1) in the caliper.
- Install the NEW inner brake pad (1) in its housing, complete with wear sensor.
- The arrow printed on the brake pad must be oriented in the direction of rotation of the disc when travelling forwards.
- Install the NEW outer brake pad (1) in its housing.
- The arrow printed on the brake pad must be oriented in the direction of rotation of the disc when travelling forwards.
- Install the brake pad pins (1).
- Install the brake caliper (1a) in its housing and install the lock pins (1b).
- Install and tighten the brake caliper mounting bolts to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the electrical harness connector at the pad wear sensor (3), secure it to the bracket.
- Pump brake pedal several times to set pads to caliper and brake rotor.
- Repeat the operation also on the other wheel of the same axle.
- Check the brake fluid level in reservoir and top up, if necessary.
- Securely tighten the brake fluid reservoir cap on the brake fluid reservoir.
- Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
- Remove the supports and lower the vehicle.
- Pump brake pedal several times to set pads to caliper and brake rotor.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Perform the brake system bleed. Refer to STANDARD PROCEDURE .
