LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning >> Plumbing >> Line, A/C Suction Jumper >> Removal And Installation >> 2.0L >> Removal

Removal And Installation: 2.0L: Removal

WARNING:

Review the safety precautions and warnings in this article before performing this procedure. Failure to follow these instructions may result in serious or fatal injury.

  1. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
    GC0198447Courtesy of CHRYSLER GROUP, LLC
  4. Remove the nut (1a) that secures the A/C suction jumper line (1b) to the A/C suction line.
  5. Install plugs in, or tape over the open refrigerant line fittings.

    Remove and discard the O-ring seal. 

    GC0198199Courtesy of CHRYSLER GROUP, LLC
  6. Remove the bolt (1a) that secures the A/C suction jumper line (1b) to the A/C compressor.
  7. Separate the A/C suction jumper line (1b) from the A/C compressor and install plugs in, or tape over the open refrigerant line fittings. Remove and discard the O-ring seal. 
  8. Remove the A/C suction jumper line (1b) from the engine compartment.
scientia non olet · About LEMON Manuals