LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Alfa Romeo >> 2019 >> Giulia Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (8HP75 - Automatic Transmission (Service Information)) >> Fluid And Filter >> Standard Procedure >> Fluid/Filter Service

Fluid/Filter Service

WARNING: This page is about a different variant/trim than selected.
NOTE:

The transmission oil pan and filter are an integrated assembly that cannot be serviced separately.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0195150Courtesy of CHRYSLER GROUP, LLC
  2. Remove the transmission oil pan drain plug (1) and allow the transmission to drain.
    GC0195013Courtesy of CHRYSLER GROUP, LLC
  3. Remove the 13 transmission oil pan/filter bolts (1a).
    NOTE:

    Inspect the gasket for reuse. If the seal is cut or torn, replace the gasket.

  4. Remove the transmission oil pan/filter (1b) and gasket. If the transmission oil pan/filter is being removed for contamination concerns discard the transmission oil pan/filter.
    GC0195013Courtesy of CHRYSLER GROUP, LLC
  5. Install the NEW  transmission oil pan/filter (1b) and gasket.
  6. Install the 13 transmission oil pan/filter bolts (1a) hand tight.
    GC0152239Courtesy of CHRYSLER GROUP, LLC
  7. Tighten the transmission oil pan/filter bolts to 10 N.m (89 in. lbs.) using the sequence shown in illustration.
  8. Check and adjust the transmission fluid level. Refer to CHECK FLUID LEVEL  .
  9. Remove the support and lower the vehicle.