Battery To PDC

REMOVAL 

1. Disconnect and isolate the negative battery cable.
2. Remove the rear belly pan. Refer to BELLY PAN, REAR SUSPENSION, REMOVAL AND INSTALLATION .
3. Remove the right side front lamp unit. Refer to UNIT, FRONT LAMP, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

4. On the battery, loosen the nut (1a) and remove the terminal (1b).
5. Remove the bulkhead seal (2a) from the bulkhead.

   Courtesy of CHRYSLER GROUP, LLC

6. Release the battery cable (1a) from the cable retaining clips (1b) in the right rear wheel arch.
7. Release the bulkhead (1c) seal.

   Courtesy of CHRYSLER GROUP, LLC

8. Position a suitable hydraulic lift with suitable brackets under the fuel tank (1a).
9. Remove the four screws (2a) securing the fuel tank (1a).
10. Using the hydraulic lift, lower the fuel tank (1a) with support brackets until it rests on the exhaust pipes.

    Courtesy of CHRYSLER GROUP, LLC

11. Release the cable retainers (1a) in the fuel tank area (1b).

    Courtesy of CHRYSLER GROUP, LLC

12. Release the cable retainers (1a) in the underbody area.

    Courtesy of CHRYSLER GROUP, LLC

13. Release the cable retainers (1a) in the right front wheel arch area.

    Courtesy of CHRYSLER GROUP, LLC

14. Lower the vehicle.
15. Remove the Power Distribution Center (PDC) cover (1a) by releasing the four retainers (1b) on the right side of the engine compartment.

    Courtesy of CHRYSLER GROUP, LLC

16. Remove the nut (1a) and the cable (1b) from the PDC.

INSTALLATION 

1. Inspect the cable from the battery to the battery terminal fuse for damage and that the individual wires are correctly fastened to the connections. If necessary, carry out appropriate continuity tests.

   Courtesy of CHRYSLER GROUP, LLC

2. Position the cable (1a) on the PDC and tighten the nut (1b) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .

   Courtesy of CHRYSLER GROUP, LLC

3. Position the PDC cover (1a) and attach all four retainers (1b).

   Courtesy of CHRYSLER GROUP, LLC

4. Install the cable in the retainers (1a) located in the right front wheel arch area.

   Courtesy of CHRYSLER GROUP, LLC

5. 1. Install the cable in the retainers (1a) located in the underbody area.

   Courtesy of CHRYSLER GROUP, LLC

6. Install the cable in the retainers (1a) located in the fuel tank area.

   Courtesy of CHRYSLER GROUP, LLC

7. Using the hydraulic lift with suitable brackets, lift the fuel tank (1a) with the support brackets until it is in aligned.
8. Fasten the screws (2a) securing the fuel tank (1a) and tighten them to the. Refer to TECHNICAL SPECIFICATIONS .
9. Remove the hydraulic lift.

   Courtesy of CHRYSLER GROUP, LLC

10. Install the cable (1a) in the retainers (1b) located in the right rear wheel arch.
11. Install the bulkhead seal (1c).

    Courtesy of CHRYSLER GROUP, LLC

12. Install the cable bulkhead seal (1a).
13. 2. On the battery, connect the cable terminal (2a) and then tighten the nut (2b) to the. Refer to TECHNICAL SPECIFICATIONS .
14. Refer to UNIT, FRONT LAMP, REMOVAL AND INSTALLATION .
15. Install the rear belly pan. Refer to BELLY PAN, REAR SUSPENSION, REMOVAL AND INSTALLATION .
16. Connect the negative battery cable.