Diagnostic Test
- CHECK FOR A SMART DOOR HANDLE CONFIGURATION NOTE:
If there are any other RF Hub DTCs, perform the diagnostic procedure for them before proceeding.
- With the scan tool select the RF Hub and verify the configuration for a smart door handle is present on the front right door.
Is a smart door handle present?
Yes
- Go To 2
No
- With a regular door handle installed, disable the Right Front Door Handle under the Miscellaneous Functions tab of the scan tool in the RFHM.
- With the scan tool select the RF Hub and verify the configuration for a smart door handle is present on the front right door.
- CHECK FOR A SMART DOOR HANDLE
- Verify that the smart sensor (magnet) is present in the door handle end cap.
Is the smart sensor (magnet) in the door handle cap?
Yes
- Go To 3
No
- Replace the Right Front Exterior Door Handle Cap in accordance with the Service Information. Refer to HANDLE, EXTERIOR, REMOVAL AND INSTALLATIONHANDLE, EXTERIOR, SUPPORT, REMOVAL AND INSTALLATIONHANDLE, INTERIOR, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Verify that the smart sensor (magnet) is present in the door handle end cap.
- CHECK FOR AN ACTIVE DTC NOTE:
If there are any other RF Hub DTCs, perform the diagnostic procedure for them before proceeding.
- Turn the ignition on.
- Using the scan tool, record and erase the DTCs.
- Make sure that the door handle is in the home position (not pulled).
- With the scan tool, select "RFH", "Data" and scroll to "Last Message: RIGHT FRONT Door Handle Hall Signal".
- Observe the value field.
Does the scan tool display: YES?
Yes
- Replace the Right Front Exterior Door Handle in accordance with the Service Information. Refer to HANDLE, EXTERIOR, REMOVAL AND INSTALLATIONHANDLE, EXTERIOR, SUPPORT, REMOVAL AND INSTALLATIONHANDLE, INTERIOR, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 4
- TEST FOR STUCK LOCK SWITCH
- With the scan tool, select "RFH", "Data" and scroll to "Last Message: RIGHT FRONT Door Handle Lock Signal".
- Observe the value field.
Does the scan tool display: YES?
Yes
- Replace the Right Front Exterior Door Handle in accordance with the Service Information. Refer to HANDLE, EXTERIOR, REMOVAL AND INSTALLATIONHANDLE, EXTERIOR, SUPPORT, REMOVAL AND INSTALLATIONHANDLE, INTERIOR, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 5
- DOOR HANDLE OPERATION
- Open the RIGHT FRONT Door window.
- Turn the ignition off and close all doors.
- Have the FOBIK outside the RIGHT FRONT Door and within 10 cm. and 1.5 m. (4 in. and 5 ft.) of the RIGHT FRONT door handle.NOTE:
In the next step, wait two (2) seconds between each Lock and Unlock activation as there is a two second delay after each Lock action.
- Lock and Unlock the RIGHT FRONT Door by the outside handle four (4) times.
Did the Right Front Exterior Door Handle Lock and Unlock the door as it should?
Yes
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
No
- Replace the Right Front Exterior Door Handle in accordance with the Service Information. Refer to HANDLE, EXTERIOR, REMOVAL AND INSTALLATIONHANDLE, EXTERIOR, SUPPORT, REMOVAL AND INSTALLATIONHANDLE, INTERIOR, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .